All slots on panel: [Panel Name] are occupied. Some circuits will be disconnected from this panel.

The distance value is smaller than the conduit diameter, please enter a larger value

The cable tray has been modified to be in the opposite direction or insufficient space to create the required fittings.

Cannot assign or add [Element] to Circuit. There is no assigned secondary distribution system for [Element].

Cannot add or assign [Element] to circuit. Electrical objects belonging to different design options cannot be connected.

A panel schedule cannot be created for these panels. A default panel schedule template must be assigned for this template type.

You have selected elements that are connected to a Panel object in a Circuit. These elements cannot be removed from the Circuit.

Total connected load for Circuit [Name] is exceeding 80% of the defined rating ([Rating Value]).

The conduit has been modified to be in the opposite direction or insufficient space to create the required fittings.

You have selected elements that are already part of other Circuits that have assigned Panels. The elements you selected cannot be added to this Circuit.

The family no longer matches the properties for the Circuit. Disconnect the family from the Circuit?

Invalid number of wires for single phase, only 2 and 3 are valid.

Invalid path of parallel conduits

Cannot add [Element] to Circuit. The Type for the available connector does not match the Type ([Name]) for the Circuit.

Cannot assign or add [Element] to Circuit. There is no assigned distribution system for [Element].

Cannot add [Element] to Circuit. The Number of Poles for [Element] does not match the Number of Poles ([Name]) for the Circuit.

The number of pole breakers may not be less than the number of occupied slots.

Cannot assign or add [Element] to Circuit. The Voltage ([Voltage Value]) for the Circuit is out of range for the Line to Line Voltage for [Element] (The Line to Line Voltage is specified in the assigned Distribution System).

Cannot add [Element] to Circuit. The Voltage for [Element] is out of range for the Voltage ([Voltage Value]) for the Circuit.

Wire Size Table "[Fail Name]" is missing or invalid. Use Electrical Settings to select a valid Wire Size Table.

Cannot add [Element] to Circuit. There is no available connector matching the Type ([Type Name]) for the Circuit.

Don't allow to rotate a horizontal cable tray/conduit like this

There are not enough slots available on panel: [Panel Name] for a circuit to be added. Please increase the maximum number of single pole breakers to be greater than [Number] or set it to 0.

Due to changes in elevation, there is not enough room to generate all of the parallel conduits. As a result, some conduit segments have not been generated.

Due to changes in elevation, there is not enough room to generate all of the parallel pipes. As a result, some pipe segments have not been generated.

The value you entered for the bend radius is zero or a negative value. Enter a positive value.

Conduit with Fittings do not support Concentric Bend Radius, the bend radius of the conduit fittings will be same.

Cannot assign [Element] to circuit. Objects that are demolished cannot be added to a circuit.

Cannot assign [Element] to Circuit. The Type for the panel does not match the Type ([Name]) for the Circuit.

You have selected elements that are already part of other Circuits. They will be removed from the original Circuits and added to this one.

The value you entered for the bend radius for conduit is too small. Enter a larger value.

Circuit is not assigned to a panel

Cannot assign or add [Element] to Circuit. The Voltage ([Voltage Value]) for the Circuit is out of range for the Line to Ground Voltage for [Element] (The Line to Ground Voltage is specified in the assigned Distribution System)."