Creates a solid by sweeping one or more closed coplanar curve loops along a path.
Namespace: Autodesk.Revit.DB
Assembly: RevitAPI (in RevitAPI.dll) Version: 22.0.0.0 (22.1.0.0)
Since:
2015
Syntax
C# |
---|
public static Solid CreateSweptGeometry(
CurveLoop sweepPath,
int pathAttachmentCrvIdx,
double pathAttachmentParam,
IList<CurveLoop> profileLoops,
SolidOptions solidOptions
) |
Visual Basic |
---|
Public Shared Function CreateSweptGeometry ( _
sweepPath As CurveLoop, _
pathAttachmentCrvIdx As Integer, _
pathAttachmentParam As Double, _
profileLoops As IList(Of CurveLoop), _
solidOptions As SolidOptions _
) As Solid |
Visual C++ |
---|
public:
static Solid^ CreateSweptGeometry(
CurveLoop^ sweepPath,
int pathAttachmentCrvIdx,
double pathAttachmentParam,
IList<CurveLoop^>^ profileLoops,
SolidOptions^ solidOptions
) |
Parameters
- sweepPath
- Type: Autodesk.Revit.DB..::..CurveLoop
The sweep path, consisting of a set of contiguous curves. The path may be open or closed,
but should not otherwise have any self-intersections. The path may be planar or non-planar.
- pathAttachmentCrvIdx
- Type: System..::..Int32
The index of the curve in the sweep path where the profile loops are situated.
Indexing starts at 0. Together with pathAttachmentParam, this specifies the profile's attachment point.
- pathAttachmentParam
- Type: System..::..Double
Parameter of the path curve specified by pathAttachmentCrvIdx.
The profile curves must lie in the plane orthogonal to the path at this attachment point.
- profileLoops
- Type: System.Collections.Generic..::..IList<(Of <(<'CurveLoop>)>)>
The curve loops defining the planar domain to be swept along the path.
No conditions are imposed on the orientations of the loops:
this function will use copies of the input loops that have been oriented as necessary to conform to Revit's orientation conventions.
Restrictions:
- The loops must lie in the plane orthogonal to the path at the attachment point as defined above.
- The curve loop(s) must be closed and should define a single planar domain (one outer loop and, optionally, one or more inner loops)
- The curve loops must be without intersections, self-intersections, or degeneracies.
- No loop may contain just one closed curve - split such loops into two or more curves beforehand.
- solidOptions
- Type: Autodesk.Revit.DB..::..SolidOptions
The optional information to control the properties of the Solid.
Return Value
The requested solid.
Remarks
Exceptions
See Also