Curve.CreateInterpolatedCurve Method (IEnumerable(Point3d), Int32, CurveKnotStyle, Vector3d, Vector3d)

CurveCreateInterpolatedCurve Method (IEnumerablePoint3d, Int32, CurveKnotStyle, Vector3d, Vector3d)

Interpolates a sequence of points. Used by InterpCurve Command This routine works best when degree=3.

Namespace:  Rhino.Geometry
Assembly:  RhinoCommon (in RhinoCommon.dll)
Syntax
Copy
public static Curve CreateInterpolatedCurve(
	IEnumerable<Point3d> points,
	int degree,
	CurveKnotStyle knots,
	Vector3d startTangent,
	Vector3d endTangent
)
Public Shared Function CreateInterpolatedCurve ( 
	points As IEnumerable(Of Point3d),
	degree As Integer,
	knots As CurveKnotStyle,
	startTangent As Vector3d,
	endTangent As Vector3d
) As Curve

Parameters

points
Type: System.Collections.GenericIEnumerablePoint3d
Points to interpolate. For periodic curves if the final point is a duplicate of the initial point it is ignored. (Count must be >=2)
degree
Type: SystemInt32
The degree of the curve >=1. Degree must be odd.
knots
Type: Rhino.GeometryCurveKnotStyle
Knot-style to use and specifies if the curve should be periodic.
startTangent
Type: Rhino.GeometryVector3d
A starting tangent.
endTangent
Type: Rhino.GeometryVector3d
An ending tangent.

Return Value

Type: Curve
interpolated curve on success. null on failure.
Version Information

Rhino for Mac

Supported in: 5.4

Rhino for Windows

Supported in: 6.8
See Also

M:Rhino.Geometry.Curve.CreateInterpolatedCurve(System.Collections.Generic.IEnumerable{Rhino.Geometry.Point3d},System.Int32,Rhino.Geometry.CurveKnotStyle,Rhino.Geometry.Vector3d,Rhino.Geometry.Vector3d)