SpotDimension Class

private void Getinfo_SpotDimension(SpotDimension spotDimension)
{
    string message = "SpotDimension's Location : ";
    Location location = spotDimension.Location;

    if (location is LocationPoint)
    {
        LocationPoint point = location as LocationPoint;

        message += "\n" + location.GetType().Name + " : ";
        message += "(" + point.Point.X + ", " + point.Point.Y + ", " + point.Point.Z + ")";
    }
    else
    {
        LocationCurve locCurve = location as LocationCurve;
        Curve curve = locCurve.Curve;
        message += "\n" + location.GetType().Name + " : ";
        message += "\nStart Point : " + "(" + curve.GetEndPoint(0).X + ", "
                    + curve.GetEndPoint(0).Y + ", " + curve.GetEndPoint(0).Z + ")";
        message += "\nEnd point : " + "(" + curve.GetEndPoint(1).X + ", "
                    + curve.GetEndPoint(1).Y + ", " + curve.GetEndPoint(1).Z + ")";
    }

    TaskDialog.Show("Revit",message);
}

Private Sub Getinfo_SpotDimension(spotDimension As SpotDimension)
    Dim message As String = "SpotDimension's Location : "
    Dim location As Location = spotDimension.Location

    If TypeOf location Is LocationPoint Then
        Dim point As LocationPoint = TryCast(location, LocationPoint)

        message += vbLf + location.[GetType]().Name & " : "
        message += (("(" + point.Point.X & ", ") + point.Point.Y & ", ") + point.Point.Z & ")"
    Else
        Dim locCurve As LocationCurve = TryCast(location, LocationCurve)
        Dim curve As Curve = locCurve.Curve
        message += vbLf + location.[GetType]().Name & " : "
        message += (((vbLf & "Start Point : " & "(") + curve.GetEndPoint(0).X & ", ") + curve.GetEndPoint(0).Y & ", ") + curve.GetEndPoint(0).Z & ")"
        message += (((vbLf & "End point : " & "(") + curve.GetEndPoint(1).X & ", ") + curve.GetEndPoint(1).Y & ", ") + curve.GetEndPoint(1).Z & ")"
    End If

    TaskDialog.Show("Revit", message)
End Sub

No code example is currently available or this language may not be supported.

No code example is currently available or this language may not be supported.